MG-IIIManual 9 | Biblioteca motores watercop

close the backwash test spigot. Next, open the OUTLET bypass on the MG-III

at 1-8

result in carbon or other material being released into the customer's home

damaged in shipment. A technical service agent will diagnose if there is a

and all test spigots are closed. Failure to close the outlet bypass valve could

manifold and allow the unit to fully pressurize, again checking for leaks.

completed, again check for granular media in the mesh bag.

Programming Instructions. As soon as the timer shows that the cycle has

you are ready to proceed to the final step. Set the time of day on the valve's

turn the mesh bag a brown or black color. If there is any granular media in the

holding the "EXTRA CYCLE" button for 5 seconds as shown on step 16 of the

Allow the filter to run through a complete backwash cycle (approx. 25 minutes).

At the end of the cycle, examine the mesh bag. The MG-III system is designed

If the system is free of leaks, initiate a backwash cycle by pressing and

slowly open the outlet bypass valve and perform a final check for leaks.

digital display to the current local time. If the backwash line is hard plumbed,

should begin flowing out of the backwash drain line. If the backwash line is

manifold. The OUTLET bypass on the manifold must remain closed. Water

hard-plumbed, open up the backwash test spigot to allow water to flow.

granules that may have escaped into the outlet line during installation from

Provided there are no leaks, open the outlet test spigot and purge the line for

use. Once they are closed, slowly open up the water main and check for leaks.

to release carbon fines into the water on initial backwash, which will typically

Next, check to ensure that the outlet bypass valve, system bypass valve,

The MG-III Home System is now ready for use.

Once water has begun to flow out of the backwash line, place the supplied

plumbed ensure that the backwash bypass valve and test spigot are also

causing significant plumbing damage. If the backwash drain line is hard

77-727-1078 immediately as there is a possibility that the unit has been

closed, and temporarily attach a hose to the backwash test spigot for later

repeat the backwash procedure once more. After the second backwash cycle is

begun (should read 1--14), slowly open the INLET bypass on the filter

1 minute (in an indoor installation a hose will be required) to prevent any

mesh bag at the end of the hose or tubing allowing the water to run through it.

problem with the unit over the phone. If there is no granular media in the bag,

being flushed into the customer's home. Once this flushing is complete,

If there is no granular media in the mesh bag after two backwash cycles,

bag please do not discard the bag or its contents and contact Wellness Support