ThermalBoard_inst-app_manual 9 | Biblioteca actuadores warmzone

ThermalboardTM to a subfloor. In absence of a groove alignment tool, cut short (6") pieces of PEX pipe.

These can be used to align the grooves of the boards during installation by snapping them into the

Recommended optional items:

ThermalboardTM Installation And Installation Manual 3/3/03 Page 9

tent of the subfloor to be sure it is in the 6 10% range. Check for excessive moisture in the crawl

accurate in the installation. If you are installing large areas of ThermalboardTM you may wish to invest

and return bury points.

Creaking subfloors must be repaired before installation. If the subfloor sags, inspect the joists below

rial as well as a compatible mastic for engineered wood products and appropriate rollers and

SUBFLOOR REQUIREMENTS, WOOD SUBFLOORS:

the manufacturer's recommendations, and allow the compound to dry completely before starting to

High areas are sanded or planed, low areas patched or filled with an appropriate leveling com-

grooves with 3" in the groove on each board. Once the board is secured they may be removed prior to the

·Square

ThermalboardTM cuts easily with a quality circular saw blade. Pieces frequently must be cut to provide

trowels

Wood subfloors must have a stable moisture content between 6 10%.

an accurate fit for each room. It is important that they be cut squarely to keep the alignment of grooves

Installers note:

for twists or weakness. If the subfloor is cupped or uneven at the joints, recheck the moisture con-

in a stand up drill so that you do not have to bend over to set every screw when glueing and screwing

See specific details that follow in the application section of this manual.

The following is necessary for the installation of Thermalboard:

SUBFLOOR REQUIREMENTS, CONCRETE SUBFLOORS:

·Table or circular saw. A carbide blade is recommended.

·Electric or cordless drill gun with No. 2 Phillips bit and 5/8" drill bit for supply

·Stand up drill

·Groove alignment tool

·If installing over concrete you may need insulation and waterproofing sealant membrane mate-

·Rubber or hard hide mallet

·Chalk line

space or basement and look for other signs of a potential water problem.

install the floor.

installation of the pipe

EQUIPMENT REQUIRED FOR INSTALLATION:

pound, or covered with a rigid underlayment. When using a leveling compound, be sure to follow