ThermalBoard_inst-app_manual 19 | Biblioteca actuadores warmzone

APPLICATION TILE OR STONE OVER SUBFLOOR:

6) Use groove alignment tool to ensure proper alignment of boards.

2) Chalk lines of a square reference point as construction of walls may be inconsistent

Installation:

going to be thin-set, anti-fracture membrane (Nobleseal) shall be used.

8) Once all boards are installed clean out all grooves with a vacuum.

3) Lay out boards according to plan.

10) Maintain 2" minimum tubing clearance when screwing backer board down.

any other area where water may be present, water sealant (Nobleseal) shall be used. Where tile is

ThermalboardTM system.

Refer to the complete installation manual for further instructions on the installation of the

7) A 1/16" width space shall be used between boards.

4) Be sure to use adequate adhesive.

9) Snap tubing into groove and route to manifold per plan.

ThermalboardTM Installation And Installation Manual 3/3/03 Page 19

Conventional mortar bed or thin set installation may then be used. In Kitchen, Baths, Laundry or

1) Thoroughly clean and level all surfaces that Thermalboard will be applied to.

For masonry Tile and Stone it is recommended that backer board be used over Thermalboard.

5) Start layout of all pieces by securing a corner to allow for proper alignment.