faxj-300 4 | Biblioteca seguridad vikingelectronics

4 seconds

distinctive ringing is routed to the DATA port. On "Normal" ring, the FAXJ-300 will still monitor for CNG, carrier

a transfer command code is detected, the call will be transferred to the DATA port. If no CNG tone is detected or a

PHONE Port

can enter a #1 to transfer the call to the DATA port.

Distinctive Double Ring Cadence

When dialed, each number will ring "distinctively." The FAXJ-300 can differentiate a distinctive ring cadence from a

1.5 seconds minimum

Product Support Line...(715) 386-8666

Note: In the manual mode, the Fax Jack does not answer the line, allowing compatibility with central office

incorrect code or no code is entered, the FAXJ-300 will direct the call to the PHONE port.

Electronics, its affiliates and/or subsidiaries assume no responsibility for errors and/or omissions contained in this information. Revisions of

All calls will pass through the FAXJ-300 to the PHONE port. If a fax is to be sent, the receiving party or the caller

D. Distinctive Ringing (see Programming, section A)

simulated ring back tones for approximately 5 seconds while the Fax Jack listens for these tones. If a CNG tone or

this document or new editions of it may be issued to incorporate such changes.

ZF290080 Rev C

up the telephone and dial #0. The Fax Jack will then hang-up.

When the FAXJ-300 answers, a beep will be heard. The caller will then have 5 seconds to enter a security code

provided voice mail.

After one ring, the FAXJ-300 will answer the line and listen for CNG tones or a command code. The caller will hear

Printed in the U.S.A.

B. Automatic Transfer Mode

C. Manual Transfer Mode

Note: In the Automatic Transfer Mode the inbound caller will hear 2 ring backs in addition to the programmed ring

E. Security Code

command code is not entered, the call will be directed to the to the PHONE port. If the PHONE port is not

standard ring cadence and route the call accordingly. Normal ring cadences will be routed to the phone port while

Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking

Normal Ring Cadence

from their Touch Tone phone. If the correct code is entered, the call will be directed to the DATA port. If an

tones and Touch Tones, before sending the call to the phone port.

DATA Port

If a phone is wired on the line side of the Fax Jack and the user wishes to stop the Fax Jack from transferring, pick

When using the feature, you are issued several telephone numbers while having only one actual telephone line.

Notes: If your "Normal" ring is less than 1.5 seconds or a double ring, etc., you cannot use this feature.

answered within the programmed ring delay, the FAXJ-300 will then transfer the call to the DATA port.

delay.

Distinctive ringing is an option provided by phone companies which permits extremely accurate routing of calls.

Fax Back Doc # 260

Fax Back Line...(715) 386-4345