times. Two confirmation tones will be heard and the relay will be activated for the programmed doorstrike activation time. The
Continuously de-activate (unlatch) doorstrike relay 1 or 2 ...................
6 ..4
Pulse dial 2 or hook flash 2 times
1 or doorbox 2 is calling. To place the in-progress call on hold and answer the calling doorbox, simply dial a Touch Tone "#",
ZF302010 Rev A
u c
Control Mode (
The C-1000B allows two CCTV video cameras to be concentrated down to one video signal, by switching to the camera at the
3. Activating a Doorstrike, Magnetic Lock or Gate Controller
n e
4 3
5
3. Remain connected to the camera near the last doorbox activated and continue feeding video, until the other doorbox is activated.
on and 3 seconds off contact pattern is generated. If doorbox 2 is activated, a repeating double burst contact pattern is gen-
Printed in the U.S.A.
in use, and a ring cadence pattern are available. Note: The auxiliary contact mode (
, #
* Pulse Dial/Flash Commands
8 6
RF modulator (Radio Shack part # 15-1214 or equivalent), which automatically switches the video source in when a video signal
Momentarily activate doorstrike relay 1 or 2 .........................................
a. Timed Activation
P rro
ferent patterns when doorbox 1 or doorbox 2 is activated. A momentary activation, a continuous activation while the doorbox is
When a momentary postal lock contact closure is made across terminals 6 & 7 (see Installation section D), the doorstrike 1 con-
e ......7
8
3 8
, 1
x B
, 2
F
Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries assume no respon-
Fax Back Doc 168
B. Doorbox Triggered CCTV Camera Switching / CCTV Video Control Mode ( , 8)
If an auxiliary contact activation time is programmed (two digits 00-10 followed by #03), when either doorbox is activated, the
a c
Activate opposite doorstrike relay ........................................................
Touch Tone Commands
Toggle relay from last position ..............................................................
3 8
6 ..8
,7) is disabled when using the CCTV Video
4. Sequence video from both cameras, rotating every 4 seconds.
6. Auxiliary Contact Mode (
tact will activate for the programmed time.
L iin
phone will then be returned to the C.O. line. If a call was in progress, the original caller will be taken off hold to continue the con-
B a
Continuously activate (latch) doorstrike relay 1 or 2 .............................
k L
c k
u p
zone/entry point being used. When the C-1000B detects doorbox ringing or when a doorbox is monitored it will connect that camera's
2. Placing C.O. Line Calls on Hold
To activate a relay contact, you must be communicating with a doorbox. Touch Tone dial "
d u
4 5
n e
,8) is disabled when using the Auxiliary Contact Mode (,7).
S u
5 ..3
5. Keyless Entry/Postal Lock
video feed to the video output. This happens in a first come, first serve manner. When both doorboxes are inactive (idle) the C-1000B
Installation section A).
,8).
Answer or disconnect a doorbox call ....................................................
Note: When on the C.O. line, if a Touch Tone other than # is entered, any additional Touch Tones in that dial string will be ignored. To regain
5 ..3
4. Features
Note: The CCTV Video Control Mode (
o d
8 6
p p
If the auxiliary contact is programmed to continuously activate (11 followed by #03), while either doorbox is ringing or in use,
L iin
Monitor doorbox 1 ................................................................................
1. Disconnect all cameras so there is no video output. This mode is very convenient when used in combination with a switching video
e ......7
a x
sibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.
# 2
3 4
,7)
If a C.O. line call is in progress and a doorbox is activated, a single or double "call waiting" tone will be heard indicating doorbox
, 0
Monitor doorbox 2 ................................................................................
pulse dial a "2" or hook flash twice.
6 6
1 5
6 6
* Note: Pulse dialing and flash commands are not compatible in the "Multiple Relay Activation" mode.
erated with 3 seconds off between patterns. Note: Ring cadence activation is not compatible with the Analog PABX/KSU
o rrtt L
is present. A home TV's broadcast/satellite program will be automatically interrupted to show video feed of the arriving guest (see
b. Continuous Activation
1 5
c tt S
Station mode.
the auxiliary contacts will latch. This is ideal for controlling lights, etc.
can be programmed to do one of four operations (See Programming, Section B, Page 6):
auxiliary contacts will activate for the programmed time (.5 - 10 seconds). This is ideal for operating a doorbell or chime.
2. Connect video feed from camera 1.
7 1
# 1
7 1
versation. To return to the original call without activating a relay, Touch Tone dial "#", pulse dial a "2" or hook flash twice.
c. Ring Cadence Activation
6
P
control of the C-1000B, the phone must be momentarily placed on-hook.
If the auxiliary contact is programmed to custom ring cadence ("12 #03") when doorbox 1 is activated, a repeating 1 second
The auxiliary contacts are a separate set of contacts that can be programmed (see Programming section B) to activate in dif-
,,
#
8 6
p o
F a
,,", pulse dial a "3" or hook flash three
Pulse dial 3 or hook flash 3 times
<< < [Pag.8]
Esta version es la html del arhivo pdf c-1000b, genearada por domotica.name desde www.vikingelectronics.com
Archivos relacionados:1900-series E-40 SL-1 SL aes-2000 c-4000 cpa-7b cpc-1 cpc ctg-1 ctg dna-510 dva-2wa dva-3003 e-10-20a-ewp e-30 e-30-pt eram-60 es-1 es faxj-300 fbi-1a hd-1 hd hf-3w k-1900-4 lc-8 ldb-2 ldb-3 lla-4 lm-1a ls-4x4 m2w moh-2l mtg-10 pa_30 pan-1 pan pb-100 pi-150w privacy ps-2r rad-1a rc-3 rg-10a so-24a ve-boxes ve-light seguridad cctvsafe extremecctv freezealarm goodbarsecurity highpowersecurity icontrol infosecinstitute intamac jacksonsystems keepsafer mraccess napcosecurity nexusaudiosystems securityandmore securitymaninc smartvue techno-mall tripplite vigitron vikingelectronics wilife
