932656 2 | Biblioteca seguridad tripplite

· Leave a minimum of 2 inches (5 cm) clearance at front and back of the Inverter for proper ventilation. The heavier the load of

cause personal injury due to electric shock. Never immerse the unit, and avoid any area where standing water might accumulate.

· Your Inverter does not require routine maintenance. Do not open the device for any reason. There are no user-serviceable parts inside.

or property damage could result.

equipment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.

· Do not install the Inverter directly near magnetic storage media, as this may result in data corruption.

Operation Warnings

connected equipment, the more heat will be generated by the unit. Any compartment that contains the Inverter must be properly

· Do not connect or disconnect batteries while the Inverter is operating. Dangerous arcing may result.

SAVE THESE INSTRUCTIONS!

· Potentially lethal voltages exist within the Inverter as long as the battery is connected. During any service work, the battery should

Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the

Inverters.

Important Safety Instructions

· Install your Inverter (whether for a mobile or stationary application) in a location or compartment that minimizes exposure to heat,

· Although your Inverter is moisture resistant, it is NOT waterproof. Flooding the unit with water will cause it to short circuit and could

ventilated with adequate outside airflow to avoid overheating the Inverter.

dust, direct sunlight and moisture.

Location Warnings

Battery Connection Warnings

· Because explosive hydrogen gas can accumulate near batteries if they are not kept well ventilated, your batteries should not be

· Multiple battery systems must be comprised of batteries of identical voltage, age, amp-hour capacity and type.

· Connect the Inverter to the battery with recommended DC fusing (see Battery Connection).

This manual contains important instructions and warnings that should be followed during the installation, operation and storage of all Tripp Lite

failure of the life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this

· Safe operation requires connecting the Inverter's main grounding screw directly to the frame of the vehicle or earth ground.

Ground Connection Warnings

ventilation to outside air.

· Do not install near flammable materials, fuel or chemicals.

· Do not allow objects to contact the two DC input terminals. Do not short or bridge these terminals together. Serious personal injury

· Do not mount unit with its front or rear panel facing down (at any angle). Mounting in this manner will seriously inhibit the

unit's internal cooling, eventually causing product damage not covered under warranty.

Inverter.

Equipment Connection Warnings

Mounting should be in the driest location available.

installed (whether for a mobile or stationary application) in a "dead air" compartment. Ideally, any compartment would have some

· You may experience uneven performance results if you connect a surge suppressor, line conditioner or UPS system to the output of the

· Sparks may result during final battery connection. Always observe proper polarity as batteries are connected.

therefore be disconnected.