sceneset 7 | Biblioteca actuadores touchplate

The outputs won't turn all the way on.

The Power Save switch is in the wrong position. Move the switch to the far right position and

When both systems are wired correctly and running the green LED on the MCD-4000 control

The CFL/HID switch is in the wrong position. Move the switch to the far left position and power

reset the system or the memory will be erased.

and scenes).

down and then power up the system or reset the system (warning: resetting will erase presets

I can't get the MCD-4000 dimmer to function.

You're in scene set mode. Either assign the scene or reset the system (warning: resetting will

The outputs won't dim all the way off.

erase presets and scenes).

I checked the power supply and it still doesn't work, now what?

The system has been altered. Check the option switches and cycle power to the unit. Do not

Nothing on the system works.

All of my scenes disappeared!

Check the inputs. It is possible that the switch common is not wired or shorted.

Try resetting the system. Press and hold both push buttons. Both the green and red LEDs should

Troubleshooting

8000D will reset properly (see previous questions).

presets and scenes).

be lit. If not, either the power supply has failed or the CPD-8000D is in need of replacement.

power down and then power up the system or reset the system (warning: resetting will erase

Check to make sure the CPS-8001 power supply is working. All three green LEDs should be lit.

The system will reset properly but I can't get anything else to function.

board will be lit solid. If the LED is flickering check the network wiring. Also make sure the CPD-

When I press any button the LEDs light up and blink, what's wrong?