vm5057r14 9 | Biblioteca actuadores temperatureguard

Dry Contact inputs pre-configured as DC-1 Alarm

To configure a Dry Contact Input it must have been

not change the normal state. (If you do not press one, go to step

l) Enter the time delay in minutes (i.e. 15 for 15 minutes)

j) Press 1 to make a change or press any other button to not make

f) Press 1 to change the normal state or press any other button to

i) You will hear "Callout time delay is xx minutes press 1 to

d) You will hear the current Normal State input (i.e. Input 1 is nor-

k) You will hear "Enter number then press pound"

n) You will be returned to the Set Limits Menu

change"

ordered as an alarm input (DC2)

Main Menu.

b) You will hear "Enter Zone"

a) From the Main Menu, press 2 to set Limits

m) You will hear the value you just entered

g) You will hear "Press 1 for Normally Closed, 2 for Normally Open"

no programmable parameters.

e) You will hear "Press 1 to change"

h) Enter 1 or 2

a change

If you do not wish to program an input press 0 to return to the

Override option or DC-3 Water Sensor Option have

c) Enter 9 to program Input 1 or * to program Input 2.

mally open)

Configuring Dry Contact Inputs