molly303_spec_sheet 3 | Biblioteca actuadores temperatureguard

Step 4

Page 3 of 3

7. Plug the power plug into 120VAC outlet.

Installation

2. Locate the temperature sensors in the refrigerator in an area close to the objects of interest.

Step 1

3. Run the wires along the inside of the refrigerator so they will not be accidentally pulled and up

5. Repeat steps 2 to 4 for the freezer.

Step 6

March 2006

to the Molly303 terminal block. Connect to terminals 1 and 2.

Steps 2,3

8. Install the DCP-E software and your monitoring system is done.

4. Locate the door sensor on the side of the refrigerator near the handle. Attach the magnet so that

This installation example is for a standard refrigerator/freezer with a temperature and door sensor for

when the door is closed the magnet and switch are opposite each other.

zone.

1. Attach the Molly303 on the side of the refrigerator/freezer with the supplied screws.

6. Connect an ethernet cable to the LAN port.