VM505E_510Emanual_and_installation 20 | Biblioteca actuadores temperatureguard

The rechargeable batteries used in the Guard are trickle charged and can

making calls.

1. Dial the phone number.

For Example:

How can I connect the Guard to a Phone Line which has a fax or an-

battery, therefore there will be no communication via a computer during a

2. Hang up one ring before the other device answers.

Using another phone line, call the Guard and verify that it answers the

Guard

Hang up.

Where is the 20 / 30 Hour Extended Batteries?

To verify telephone communications, perform the following test.

Troubleshooting

as well. Local alarm buzzer does not sound during a power outage..

How long does it take to charge the battery?

This allows the other device to always answer first. To call and access the

call to your programmed tele-

4. The Guard will answer.

Program the Guard to answer after one more ring than the other device.

The Guard will wait the programmed power outage delay and then begin

factory and is inside the Guard.

Enter #999 for the PIN. (including "#", pound sign)

The Guard is programmed to answer after 5 rings. To access the Guard,

A fax machine on the same line as the Guard is set to answer after 4 rings.

The Guard will perform a test

call again. After two rings, the Guard will answer.

swering machine connected to it?

Verify at least one programmed telephone number.

3. Wait no longer than 30 seconds, then dial the phone number

dial the number, let it ring three times, then hang up. Wait 20 seconds and

take up to a week to reach full capacity. The batteries are charging when-

Call the Guard again.

Please note the Guard does not power the Ethernet Port with the back-up

Hang up.

ever the monitor is powered on.

again.

If your unit has been ordered with an extended battery, it is installed at the

phone.

What happen when the power goes out?

Verifying telephone communication

power outage. Door sensor inputs are not monitored during a power outage