VM505E_510Emanual_and_installation 19 | Biblioteca actuadores temperatureguard

If the Guard has called all programmed contact numbers without having the

"sensor 2 recorded message", is 89 degrees and has been out of limits

voice mail system's outgoing message to stop.

correct PIN number entered, it will wait 20 minutes and repeat the sequence

For voice contact numbers, the Guard will play the recorded personal

When the power has been out for greater than five minutes.

Warning Messages section.

locally or remotely.

The Guard will ask for the PIN number.

next programmed contact number.

the alarm. (Alarm relay does not come on in a power outage condition).

number on the pager screen. The Guard will then hang up and call the

The Guard will wait for a person or voice mail system to answer the call.

When is a sensor/input in alarm condition?

If the correct PIN number is not entered the Guard will call the next pro-

peat the warning message. This warning message can be repeated up to 2

When a temperature sensor has been out of limits for greater than the pro-

The Guard will report any alarm conditions (i.e. "Warning, Sensor 2,

still exists and the reminder call has been enabled.

For pager contact numbers, the Guard will print the Local Identification

grammed time delay.

for, x hours and y minutes."

grammed contact telephone number.

Frequently Asked Questions

first digit. The Guard will dial all digits following the *.

When a temperature sensor opens or shorts after having been connected.

until the alarm condition goes away or the Guard receives confirmation either

If the contact number was programmed as a pager number (* is the

What happens when the Guard calls?

buzzer, and then waits two minutes to allow local personnel time to react to

times by changing the programmed value. See the Programming Repeat

When a door sensor has been open longer than the programmed time delay.

Once the PIN number has been entered, the Guard will not call again be-

The Guard will dial the contact number exactly as it was programmed.

When an alarm condition first occurs, the Guard turns on the alarm relay and

identification message.

If the correct PIN number is not entered within 4 seconds the Guard will re-

cause the current alarm condition has been acknowledged, unless the alarm

The Guard will beep while it waits for a person to stop speaking or the