VM500-5_Installation_Checklist Biblioteca actuadores temperatureguard

installation.

Installation Checklist for VM500-5

Sensor connections to extension wire are made with splices, wire nuts, or permanent

For environments with wireless/radio frequency communication or other EMI

RJ11 Jack to Analog Telephone Line with surge suppression within 6˝ feet of device. (Device is

Available Area

For longer runs (25 to 300 feet) or facility installations, twisted pair cable (such as

CAT5/CAT6 cable or Temperature Guard part #WIR-INDUSTRIAL) is recommended.

Temperature Guard part #WIR-STANDARD) can be used.

Device Mounting

For even longer runs (300 to 800 feet) or facility installations, 18AWG or better twisted

Temperature sensors are 2-wire sensors wired to the VM500-5 directly or using 2-conductor

For short runs (under 25 feet) and installations in office environments, flat cable (such as

1/25/2008

cable to built-in screw terminal blocks.

Š2007-2008 Microtechnologies, Inc.

Power/Electrical Connection

Telephone Connection

supply retailer)

connections.

A mounting template can be downloaded from:

generating equipment, 18AWG or better shielded-twisted pair cable (such as Temperature

The screwdriver required for connections is included with the device.

Door sensors are 2-wire devices wired to the VM500-5 via 2 conductor cable.

(Device is shipped with 6 foot Wallmount power supply)

Device Connections

Revision 2.0

Guard part #WIR-INDUSTRIALPLUS) is recommended.

120VAC Power Outlet with surge suppression within 5˝ feet of device.

The VM500-5 has built-in mounting flanges on the back side of the device for a surface mount

The VM500-5 requires roughly 8" x 11" of clear wall space for installation.

pair cable (such as Temperature Guard part #WIR-INDUSTRIAL) is recommended.

shipped with 7 foot telephone cable. Longer cables are available from any electronics / building

Sensor Connections

Page 1 of 1