UPB_Plugin 5 | Biblioteca actuadores pcslighting

your system requires absolutely no changes to your HomeSeer programming. Just use

that you pressed a keypad button. You can even have HomeSeer turn on/off he key

on/off or dim to their link #4 preset states, all at the exact same time.

However they can each have one "Scene" as a default behavior. Links 7 and 10 are there

the house alarm is set).

UPStart to add or remove the device and its link associations as desired.

All the links but 7 and 10 are primarily there to have group control of a set of lights.

If you want to control HomeSeer events with your UPB Keypads, just have the keypad

http://www.homeseer.com/support/index.htm

forum located at http://board.homeseer.com/forumdisplay.php?f=779

(that are UPB controlled of course) to immediately go on.

Sending "Snap On" to "First Floor Lights" (#4) will cause all the lights on the first floor

Sending "Activate" to "First Floor Lights" (#4) will cause all of the first floor lights to go

transmit a link command when the button is pressed. This will allow HomeSeer to know

The great thing about using links to their fullest is that adding or removing a device from

For additional resources please visit the HomeSeer support page at

indicator to let you know the current condition of something in the home (for instance if

to add additional scene capability to a room or area.

If you need assistance using the UPB plug-in there is a dedicated HomeSeer UPB support