ZED-2Manual 9 | Biblioteca seguridad nexusaudiosystems

to set proper audio level to the ZED-2. When the last sub-zone is turned OFF, the ZED-2 sends a

ZED-2 and no additional programming or setup is required.

the keypads all on the same wire. Special care must be used in making the Speaker/Keypad

Zone OFF command to the C-6 to turn the zone OFF. These are all automatic functions of the

same source, the two sub-zones will maintain independent ON/OFF, volume, mute and tone

System operation will be the same for sub-zones connected to a ZED-2 as regular zones

As described in the section on Wiring, the Speaker/Keypad Terminals are specially configured for

PROGRAMMING

zones.

Keypads

Instructions for additional information.

end to the appropriate sub-zone speaker terminals. Be sure to maintain proper polarity and be

connected to a C-6, X-1 or X-2 with one exception. The K-8 and K-22 Keypads and R-1 Remote

1.Using four conductor stranded wire, strip approximately Ľ" of insulation from each conductor.

NOTE: The ZED-2 automatically sends an ON command to a C-6 that lets the controller know

Twist the strands until tight.

OPERATING SUB-ZONES FROM THE ZED-2

3.Plug connector into the Speaker Output terminal on the back of the Keypad. Connect the other

accessories. Be sure to maintain proper polarity from the L+, L-, R- and R+ terminals for each

Controller as described in the C-6 Installation Instructions.

other end into one of the two sub-zone output terminals on the ZED-2. Repeat for both sub-

accessories. Be sure to maintain proper polarity on the LEFT+, CONTROL, COMMON and

There is no additional programming required for sub-zone configuration using a ZED-2. All

Phantom Control that combines speaker level audio signals, keypad control signals and power for

2.Connect the bare wires to the plug-in four terminal screw connectors included with the ZED-2

controls.

programming of the keypads and IR command recognition for the R-1 Remote is done at the C-6

will function the same in a zone or sub-zone. See `Operating Instructions' in the C-6 Installation

connection configuration.

1.Using two conductor stranded wire, strip approximately Ľ" of insulation from each conductor.

Speakers

could cause a short.

speaker pair output. Be sure there is no loose strands sticking out that could cause a short.

Twist the strands until tight.

when a sub-zone has been activated. The ZED-2 will then send a preset volume level to the C-6

2.Connect the bare wires to the plug-in four terminal screw connectors included with the ZED-2

3.Plug connector into the Speaker/Keypad Input terminal on the back of the Keypad and plug the

connections.

sure speaker connections are tight. Repeat for both sub-zones.

The Speaker Output Terminals output speaker level audio only and use a standard speaker

RIGHT+ terminals for each zone output. Be sure there are no loose strands sticking out that

The exception to standard operation is that in `Zone Sharing' while both sub-zones will share the