T2InstallationV1 9 | Biblioteca seguridad nexusaudiosystems

This section provides instruction to connecting a T-2 to a typical whole-house A/V distribution and

Using a 3.5mm mini to mini plug cable, connect the appropriate IR OUT of the whole house

control system. If using a Nexus Audio C-6 Controller, see the section: CONNECTIONS/Nexus C-

6, following. Connections for the Nexus Audio T-2 are fairly simple, basic connections that should

AM/FM Tuner

Using a quality stereo RCA to RCA cable with gold connectors, connect the T-2 AM/FM

Typical System

CONNECTIONS

IR Control

attention should be paid to those steps.

only take a few minutes. Antenna placement is always critical in setting up a tuner, so some extra

control the tuner directly or `teach' the T-2 Remote IR commands to an integrated IR Remote.

NOTE 1: This is an optional connection depending upon system configuration. If connecting

Tuner L&R line level audio OUT to the L&R line level audio IN on a whole-house A/V

T2-121506-1

If using RS232 for control, the IR connections are not required.

Figure 4. Typical System Connections

A/V Controller to the T-2 AM/FM Tuner IR Jack. Polarity: Tip=Signal; Sleeve=Ground.

Audio

the T-2 to a preamp or controller that does not have IR Outputs, use the T-2 Remote to

Controller (Source 1 Figure X) or other audio preamp/controller.