C-4-4InstallationInstruct 9 | Biblioteca seguridad nexusaudiosystems

C-4.4 Installation Instructions

be turned off, after a five second delay, the C-4.4 will output the source power toggle commands to

Mode, IR Receiver Enable/Disable, Last/Default Volume and Primary/Secondary Keypad settings.

membrane and key caps for installation and normal use. (The keypad bezel is removable to allow

Rev 1; 6-25-07

Figure 4 K-4.4 Keypad Rear Panel

22. Volume Control Buttons Two buttons provide control of local zone volume.

the local zone on and select the last source selected. A second press will turn the local zone off. If the

configuration of the Source Button Labels.)

zone being turned on is the first zone in the system to turn on, the C-4.4 will automatically output the

23. Zone Configuration Switch One four position DIP switch allows local zone configuration of Group

membrane and key caps for installation and normal use. (The keypad bezel is removable to allow

24. Controller Port One RJ45 jack connects to the appropriate Zone Input on the C-4.4 rear panel via

20. Power Button One button serves multiple purposes. In typical use, one press of this button will turn

K-4.4 KEYPAD REAR PANEL

21. Keypad Bezel Tab Slots Four slots lock the keypad bezel tabs in place, securing the bezel, rubber

CAT5 cable terminated with RJ45 connectors. The cable CAT5 should be configured in a pass-

configuration of the Source Button Labels.)

source power toggle commands to turn all sources on. If the zone being turned off is the last zone to

21. Keypad Bezel Tab Slots Four slots lock the keypad bezel tabs in place, securing the bezel, rubber

through (pin to pin) configuration, utilizing the TIA568A Standard pin-out.

turn all sources off.

See Section: Zone Setup for additional information.