high limit (HL-170) should be wired to the "HL"
Panel
thermostat back down before checking the next
Zone #2 Damper
thermostat mode switches in heat mode and turn
The low limit (FS-38) should be wired to the
terminals on the zone control panel.
single-stage heat / cool thermostats. The thermostats
Verify that the jumpers across the "LL" and
own space thermostat and motorized zone damper.
Website:
down all thermostat set points. Go to each zone
heating or cooling equipment will also be brought
If one of the zone thermostats is calling for heating
www.jacksonsystems.com
(and the rest are closed).
the system will operate in the cooling mode.
Zone #1 Damper
system that allows a single HVAC unit to have up
the disconnect for the condensing unit to prevent
11-17-03
can be either manual or auto changeover.
To check the system for proper operation, pull
and another zone thermostat is calling for cooling,
·
Might Serve
proper terminals and are secure.
888.652.9663
When the thermostat that is calling for cooling is
turns off and all zone dampers return to the open
"LL" terminals on the zone control panel. The
connected together). Each zone is controlled by its
Zone dampers can be either 3-wire (powered
of the heating requirement. This is referred to as
satisfied, the system will change over and take care
Zone #1
Transformer
2-wire dampers use C and PC.
dampers powered closed, and the zone(s) calling
Sequence Of Operation
System Checkout
"HL" terminals were removed before connecting
Comfort SystemTM
E-mail:
If any of the zone thermostats call for heating or
The zone control system works with multi-stage or
Zone Control
Turn the zone
Verify that all wires have been connected to the
closed / spring return open).
Typical System
cooling, the zones not calling will have their
Next, place all the zone
Z-300-HC-MS Multi-Stage Heat / Cool Zone Control Panel
Conference Room
Stat
zone.
info@jacksonsystems.com
317.227.1034
Zone #2
Comfort SystemTM is a commercial zone control
Thermostats
thermostat, one at a time, and call for heat to
the one calling for cooling will take priority and
Stat
position to allow for continuous air circulation.
verify that the proper zone dampers are open
Office Area
3-wire dampers use PO, C and PC.
on at the same time. When all zone thermostats
will have its (their) damper(s) remain open. The
are satisfied, the heating or cooling equipment
When a green zone LED is on, that zone is
to three separate zones (nine if three panels are
5418 Elmwood Avenue
the high and low limit stats.
24 Volt 40VA
Might Serve
Indianapolis, IN 46203
"Auto Changeover - Cooling Priority."
calling for heating or cooling.
short cycling.
Toll-Free:
·
closed / powered open) or 2-wire (powered
Fax:
< [Pag.2]
Esta version es la html del arhivo pdf z300_hc_ms_install_sheet, genearada por domotica.name desde www.jacksonsystems.com
Archivos relacionados:Catalog-004 GreenRibbon Green_HO_she RSESarticle SL-2000logo Z-200-HC-IOS Z-200-HP-IOS Z-2000end Z2000-Round- Z2000book ZDRect aprilaire_au aprilaire_hu bd_series_ba bypassdamper certificate concealstatf creditapp d_series_rec d_series_rou ductworksizi energy_savin fact_sheet homeownerbot patch retrodamper stats_on_sta tempstatfaq trimed_uvlam vav wr_1F78_144 wr_1F85_277 wr_1F93_380 wr_bluetouch z200HP z200saleslit z300_hc_inst z300_homeown z300_hps_dat z600saleslit zone_one zone_one_dat zone_one_mod seguridad cctvsafe extremecctv freezealarm goodbarsecurity highpowersecurity icontrol infosecinstitute intamac jacksonsystems keepsafer mraccess napcosecurity nexusaudiosystems securityandmore securitymaninc smartvue techno-mall tripplite vigitron vikingelectronics wilife
