tempstatfaq Biblioteca seguridad jacksonsystems

Yes; however, the easiest way is to use the "ssu" switch that is almost always

· Do heat, moisture and vibration cause any problems?

would be wired across "W" and "R". Depending on the equipment, a jumper may be

3/13/2001

· What is the warranty?

1 ½ degrees Fahrenheit.

and off?

Use it with only 24 Volt control circuits with a maximum current of 1.0 Amp. Use a

· What type of control circuit should be used with Temp-StatTM?

· What is the temperature differential of Temp-StatTM?

Heat and moisture do not affect Temp-StatTM; however, vibration could cause it to

Temp-StatTM has a one (1) year warranty.

· Is there any limitation on the thermostat wire run length?

· What is the expected life of a Temp-StatTM?

It is simply connected across the "W" and "R" terminals (just like any heat-only

· How is Temp-StatTM wired?

installed in the control circuit of the cooling unit (some units may have this built in).

the same limitations of any other standard thermostat.

relay kit (CS-RY-115 or CS-RY-220) if controlling a line voltage circuit.

· Can a Temp-StatTM be used for cooling applications?

Temp-StatTM Frequently Asked Questions

work improperly. It is recommended that it not be mounted on any vibrating surface.

No; Temp-StatTM is not an electronic sensor, it is a special bimetal thermostat with

(assuming the changeover valve is energized on a call for cooling).

· How is Temp-StatTM wired for a heat pump?

on a rise in temperature. It is recommended that a 2-wire short cycle timer be

It is the same as any other standard thermostat.

· Can a simple switch be used in series with Temp-StatTM to turn the furnace on

Typically the resistance heat is operated during construction; therefore Temp-StatTM

compressor is to be used for temporary heat, simply wire across between "Y" and "R"

installed at the side of the furnace to turn it on and off.

thermostat).

required between "W" and "G" at the air handler to control the fan; however, if the

Yes; however, a cooling version (CL-70 or CL-75) must be used because it "makes"