YALEHSA3095Manual 19 | Biblioteca seguridad intamac

you wish to take down a detector that has tamper

mode), the display can be cleared as described in

mode.

disarmed. To enable the display to be cleared a

been closed. The display is cleared by entering

if a detector has been tampered the display can

only be cleared once the detector tamper has

once the detector is activated (out of `Walk Test'

your PIN code, pressing OK, and exiting the `Arm

an alarm even when the system is disarmed. If

The control unit will identify the device

triggering a tamper alarm when the system is

is activated. To be able to clear the display the

Tamper display

batteries in the detector will have to be changed.

Low battery display

`Tamper display'.

When a detector's batteries are running low, it

Home' display by pressing

protection ensure the control unit is in `Walk Test'

Always use alkaline batteries as replacements and

ensure the control unit is in `Walk Test' when

Please note that detector tampers will trigger

tamper condition has to be rectified. For example,

will signal its condition to the control unit when it

taking down detectors. After changing batteries,