as furniture. Pet tolerance also decreases the
location mark (as shown in Fig. 7) is on the
setting if you desire.
drilling and drill the holes. Then screw the
off alerts whilst entering or leaving your home.
the screws provided. Make sure the magnet
screw. Fig 7.
Fig 7.
any activity sensed within the line of sight will
remain below a height of 1m (3') meaning they
· Attach the base to the mounting surface using
to the Control Panel the Movement Detector will
· Position the magnet on the door or window
· Re-attach the circuit board to the base, by
within a chosen room.
mode again as long as it has not been disturbed.
allow you to walk past the sensor without setting
· Hold the sensor base against the mounting
tighten the screw.
Avoid excessive handling.
closer the animal is to the detector.
· Remove the cover by unscrewing the closure
up to approximately 36kg (80lb) do not trigger
trigger an alert. The sensors are defined as
VP1000 is switched on, the siren will sound
near to your Control Panel you may want to
There are two pet smart Movement Detectors
magnet to the mounting surface using the
MOUNTING USING SCREWS
SECTION
HOME & HOUSE within the default settings.
have installed the system, you can change this
sensors. Their purpose is to sense movement
an alert message. However larger pets must
battery power. Once the duration of the SLEEP
and detach the circuit board from the base.
gently into place. Then replace the cover and
As soon as the Movement Detector is installed,
BT Home Monitor ~ 8th Edition ~ 26th March '03 ~ 5296
surface and mark the points for drilling. Then
8
provided with your BT Home Monitor VP1000
2
· Gently pull apart the base from the cover.
face magnet
go into SLEEP mode for 90 seconds to save
· Gently bend back the circuit board retainer
drill the holes in the mounting surface.
inserting it into the edge supports and clicking
screws provided.
This means that when the BT Home Monitor
mode has passed, the detector will be in ready
they are described as passive infrared (PIR)
INSTALLING THE MOVEMENT DETECTOR
If you need to locate your Movement Detector
alongside the transmitter. Mark the points for
Closure screw
should not be allowed onto higher surfaces such
When movement is detected and a signal is sent
change the setting to WALK THRU which will
correct side.
Marking must
immediately if the sensor is triggered. Once you
The pet smart sensors are designed so that pets
<< < [Pag.9] > >>
Esta version es la html del arhivo pdf HMVP1000MainUserGuideV8_000, genearada por domotica.name desde www.intamac.com
Archivos relacionados:ASIALIAGarti BTHomesafeIn BarnetCounci ConsumerElec IntamacCance IntamacUserG IntamacUserG PaymentMetho Peterborough TermsandCond YALEHSA3095M directions_b moneyfloodin termsandcond seguridad cctvsafe extremecctv freezealarm goodbarsecurity highpowersecurity icontrol infosecinstitute intamac jacksonsystems keepsafer mraccess napcosecurity nexusaudiosystems securityandmore securitymaninc smartvue techno-mall tripplite vigitron vikingelectronics wilife
