SpaTempInst Biblioteca motores innovativepools

PHE or Pool Heat Enable

a 100 degree readout will read 100 if the heater is not firing or 1.00 if the heater is firing.

your entire system. The SpaTemp comes with peel and

the L-1 and L-2 items to launch Quick Key macros from inside the spa.

4.) When you have selected the device from the list you may either press another button to program on the

stick labels that can be placed over the LED indicator for a

dun. For Done. Sorry but it's only a 3 digit display.

SpaTemp

Hb or Heat Boost. This fires the heater for 2 minutes to take the spa above the spa set point if desired.

Heater On Indicator.

3.) Press the up or down arrows until you reach the desired device that you wish to control from that button.

To change from the factory settings

Top Right is Aux 2, Bottom left is Heat Boost, Bottom Center is PLC code 1 for Pool Lights on light dimming module,

SHE or Spa Heat Enable

Programming Instructions

Display

play will read 3 dashed lines. - - -. Until the filter pump has ran for 1 minute.

Page 1

The SpaTemp comes from the factory with the following settings. Top Left button is always spa. Top Center is Aux 1,

time visibility and is fully programmable from spa side. It

List of items that can be controlled.

displays temperature and the status of the Spa Function

The display will read the temperature of either the pool when in the pool mode or the spa when in spa mode. The dis-

Bottom Right is PLC code 2 for Spa Light on light dimming module.

The 3 digit LED display will light the left decimal point when the heater is actually firing.

5.) When you are finished press both the up and down arrow buttons at the same time. The Display will read

The SpaTemp spa side control is back lit for good night

backlit label that can easily be seen in the dark.

functions is a snap, so this unit is capable of controlling

SpaTemp and program it or.

FP for Filter Pump

Example: if the temp is 98 and the heater is not firing the display reads 98 If the heater is firing the display reads .98

change the heater set point. Programming the auxiliary

Optional Spa Side Control

Aux 1 through Aux 6.

L1 and L2 which send a PLC code to optional light dimming modules for pool and spa lights. You can use

1.) Press both the up and down arrows at the same time. The Display will read PRO

2.) Press the button you would like to change and it's LED will begin to flash.

and up to 5 additional functions. It also allows you to