SmartManual3.2 20 | Biblioteca motores innovativepools

2. Press Pool Heater Setpoint or Spa Heater Setpoint.

numeric key pad. The Pool Temperature is

Temperature is a 3 digit Set Point. To enter

If the desired temperature is not reached,

leave your Spa Heater Enabled so you

C. The Pool Heater is enabled if in the Pool Mode or the Spa Heater is enabled if in the Spa Mode.

temperature. These set points are factory set to 80 degrees F for the Pool and 100 degrees F for the Spa.

type in the desired set point from the

fully programmable.

To reset the Temperature from the Main Menu.

3. Enter the desired set point and press enter.

only have to press the Spa Button to

you may have to increase your filtering

Enabled for the Pool and Spa separately

a 2 digit set point and the Spa

time. Normally you will probably want to

Note:

fire the Pool Heater whenever the pool is

You can set the Set Points without

what the current Set Point is for either the

Activate the filter pump, change the valves

to the Spa Mode and heat the Spa to the

filtering. The Heater will continue to fire

D. The temperature of the water is less than the temperature set point.

a Spa Set Point of 98 degrees you must

desired temperature.

from the Pool Menu. In the figure to the

1. Press Setup in the Nav Bar.

Pool or Spa. If you don not wish to change

would like to change the Set Point simply

Page 20

mum Pool Set Point is 99 degrees, the

until the normal filtering cycle is complete.

The Smart Touch system has a temperature set point for the Pool temperature and a separate set point for the Spa

press 098 and then hit Enter. The maxi-

A. The Filter Pump has been pumping water for at least one minute.

Setting Pool and Spa Temperature

Left the Pool Heater is Enabled and will

the set point simply press Cancel. If you

Both the Pool Heater and Spa Heater are

Enabling the Heater to fire. The Heater is

until the desired set point is reached or

The temperature set point is now set, however the heater will not fire unless the following conditions are met.

B. The water temperature is being displayed in at the Smart Touch Power Center.

maximum Spa Set Point is 104 degrees.

The Temperature Setting Screens show