low, the unit is OFF (or sequencing OFF). Simply
leads if needed.
loads that exceed 20 amps (16 amps PRO-E). To
units. Remember: turning any key lock switch
The key lock switches on each unit's front panel
The STATUS lines work the same in either
REM
sync, resulting in some units turning on and
though it will temporarily turn the output of that
units other than disconnecting AC power to all
position, check the polarity and reverse the LED
mode. Each reflects the true state of the unit's
STATUS
contact switch, the RS-1 is not an appropriate
whether your building's wiring can accommodate
on the REM IN terminal. All remote switches or
(whether by an actual remote switch or by any
PS-PRO II, as discussed in the sections above.
used to illuminate an LED at the remote location
unit off. If it is turned back to REM, the PS-PRO
START ON-OFF SEQUENCE pushbuttons on
you can use more than one PS-PRO II to handle
state is still ON.
STATUS TERMINAL
The STATUS terminal is an output that may be
feature:
LED does not light when the switch is in the ON
IIE's, consult a qualified electrician.
sure that the mode (momentary or maintained) of
PS-PRO II.
when several PS-PRO II's in parallel fall out of
II will sequence back to ON because the stored
one or more momentary switches to the nearest
proper choice. Please contact Furman for RS-2
(or at least in the process of sequencing ON); if
input for each PS-PRO II should come from a
PS-PRO II's will change state (from on to off or
state and by the key lock switch. A separate
P S - P R O I I - P O W E R C O N D I T I O N E R / S E q u E N C E R
any unit's front panel will toggle all of the units.
control them remotely with one or more remote
To avoid tripping house breakers, the power
without affecting the other units.
GND
connect the indicator LED between STATUS
MOMENTARy MODE
switches, connect (in parallel) the REM, +12V
to REM. Connect a single maintained switch or
multiple fully-loaded PS-PRO II's or PS-PRO
all units is set the same. Set all key lock switches
LED must be used to indicate the status of each
If multiple PS-PRO II's are controlled by one
(and optionally GND) terminals of all units. Be
STATUS
momentary mode. The Furman RS-2 is the
unit's START ON-OFF SEQUENCE switch) will
or more momentary remote switches, all of the
CLASS 1
separate 20 amp AC circuit. If you are unsure
MULTIPLE UNITS
to OFF does not affect the stored state, even
remote switch for the PS-PRO II when it is in
PRO II's outlets. If it is high (+5V), the unit is ON
others turning off when a remote button is
vice versa) on each rising edge of the voltage
LED
will turn off an individual unit that is currently on
and ground (do not use a series resistor). If the
back in sync. This is the only way to re-sync
pushed, the remote signal line has a special
WIRING
wiring diagrams.
outlets and is affected by both the "memorized"
indicating that the power is available at the PS-
+12V
force all units to the OFF state, putting them
To address the unusual (hopefully rare) instance
OPTIONAL
Holding the REM line high for at least 4 seconds
8
<< < [Pag.9] > >>
Esta version es la html del arhivo pdf PS-PRO_II_manual, genearada por domotica.name desde www.furmansound.com
Archivos relacionados:AC-215_datas ACD-100_data ACD-100_manu AR-1215_AR-2 AR-1215_manu AR-1230_data AR-15_datash AR-15_manual AR-20_datash AR-PRO_datas AR-PRO_manua ASD-120_data ASD-120_manu Furman_Merit Furman_Merit HDS-16_HRM-1 HDS-6_HR-6_d HDS-6_HR-6_m HR-2_manual IT-1210_IT-1 IT-1230_manu IT-20_II_dat MERIT_SERIES MERIT_SERIES PL-8_PL-PLUS PL-8_PL-PLUS POWER_FACTOR POWER_FACTOR POWER_LINK_d POWER_STATIO PS-8R_II_dat PS-8R_II_man PS-8_PS-8R_P PS-8_PS-8R_d PST-6_manual PST-8_D_manu RACKRIDER_PW RL-I_RL-LED_ RS-1_RS-2_ma SERIES_II_15 SERIES_II_15 SERIES_II_20 SERIES_II_20 SP-20A_datas SPB-8C_datas SPB-8C_manua SPB-8_datash SPB-8_manual audio acousticmagic acousticsfirst amina aperionaudio audiocontrol audioquest audioshare.net auralex bowers-wilkins bryston.ca caryaudio casatools cascadeaudio chillsound conextionsystems definitivetech eliteavdist furmansound lindelectronics martinlogan monitoraudiousa mseaudio nilesaudio noble-fidelity phasetech psaudio puristaudiodesign qsonix russound sheersoundcable sherbourn sonance ticcorp triadspeakers truaudio vdn-otl
