Service Department: (707) 763-1010, ext. 40. Please write your R/A Number
of three years from the date of purchase. The Purchaser of the product is allowed
facturer does not warrant against damages or defects arising out of improper or
Instruction Sheet
by the Purchaser of the product. Manufacturer shall, at its own expense, furnish
facturer shall be to repair or replace the defective Product in the manner and for the
are much preferred to speakers for cueing overdubs. Even if
abnormal use of handling of the Product; against defects or damages arising from
headphones, each with its own volume control.
OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES
Warranty claims should be accompanied by a copy of the original purchase invoice
Stations, it is recommended that the amp have no more than
1997 South McDowell Blvd.
the Left and Right Inputs on the HA-6A's rear panel. If this mix
2 has two stereo volume controls and two headphone jacks, to
NOTE: All equipment being returned for repair must have a Return
improper installation, against defects in products or components not manufactured
THE FOREGOING IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS
and Pin 1--low, common to both channels.
called satellites) are intended for use with the Furman HA-6A
up a complete recording of many tracks, adding one or more new tracks
.
The HR-2 Remote Stations are compact boxes which eas-
In many situations, it may be sufficient to plug all headphones
Phone: 707-763-1010 · Fax: 707-763-1310
ages. Manufacturer's employees or representatives' ORAL OR OTHER WRITTEN
from Furman Sound. This warranty also does not apply to Products upon which
SPEAKER B-SATELLITE/REMOTE output on the rear panel of the HA-6A.
each musician must have easy access to his or her headphone
channel or less to convert them to use as headphone distribution
50 watts/channel maximum output to preclude the possibility of
showing the purchase date; this is not necessary if the Warranty Registration was
Authorization (R/A) Number. To get an R/A Number, please call the Furman
by Manufacturer, or against damages resulting from such non-Manufacturer made
Furman HR-2 Headphone Remote Stations (sometimes
STATEMENTS DO NOT CONSTITUTE WARRANTIES, shall not be relied upon by
The HR-2 Remote Stations connect in "daisy chain" fashion to the
In the recording studio, headphones are most often used in
ily attach with a thumbscrew to any microphone stand. Each HR-
THIS WARRANTY IS EXCLUSIVE. The sole and exclusive obligation of Manu-
If a power amplifier other than the 20 watt/channel Fur-
completed either via the mailed in warranty card or on-line website registration. Ship-
Furman Sound, Inc., having its principal place of business at 1997 South
ears (or both speakers, if used).
required adaptor built in.) Each HR-2 box can accommodate two sets of
McDowell Blvd., Petaluma, CA 94954 ("Manufacturer") warrants its HR-2 (the
on an HR-2 box may be hung on a belt if no microphone stand is conve-
be wired as follows: Pin 3--left output, high; Pin 2--right output, high;
directly into the HA-6A. However, in a larger studio, or when
a replacement Product or, at Manufacturer's option, repair the defective Product.
ranty during the warranty period (as herein above specified), Purchaser shall notify
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Manu-
accommodate two listeners. There are also two XLR connectors, one male
Product. If any part of this Limited Warranty is determined to be void or illegal, the
mixing buss on the recording console, which is then routed to
and one female, for use in daisy-chaining units together. If desired, the clip
them more conveniently. With the use of a simple adaptor, HR-2's
background image
Headphone Remote Station
period provided above. Manufacturer shall not have any other obligation with respect
Daisy-chaining HR-2 Remote Stations to the HA-6A
connects the second HR-2 to the third HR-2; and so on. If low impedance
in synchronization with previously recorded tracks. The musi-
Return shipping charges back to Purchaser will be paid by Manufacturer.
960024-693
Use of Headphone Remote Stations
in the control room.
remainder shall remain in full force and effect.
fifteen days from the date of purchase to complete warranty registration by mail or
to the Products or any part thereof, whether based on contract, tort, strict liability
headphones are used, up to twelve HR-2's may be chained together. If
puts to a single male XLR connector will have to be made. This should
MODEL HR-2
prominently on the front of the package.
www.furmansound.com · E-mail: info@furmansound.com
Purchaser, and are not a part of the contract for sale or this limited warranty. This
Petaluma, California 94954-6919 USA
medium or high impedance headphones are used, 25 or more Remote
on-line at the Furman website. If the Product does not conform to this Limited War-
with each overdub.
amplifiers. (The Furman SP-20A Half Rack Power Amplifier has the
Headphone/Monitor Amplifier to increase the number of
headphones, and play along with them. In this way, it is possible to build
Manufacturer warrants to the original Purchaser of the Product that the Product
may also be used with any stereo power amplifier of 50 watts per
headphones are used, it is important that they clamp tightly to the musi-
Stations may be chained.
Using HR-2's with Standard Power Amplifiers
headphone stations beyond the six provided, and/or to locate
Headphone Remote Station
Headphone Remote Station
"Product") as follows:
repairs have been affected or attempted by persons other than pursuant to written
Recording and Rehearsal
at strategic locations around the room. In this case, the HA-6A (or the
This output is a male 3-pin XLR connector, so that ordinary microphone
ping charges to the Furman factory or to an authorized repair location must be prepaid
damage to the HR-2's. Also, an adaptor to connect the left and right out-
otherwise, shall Manufacturer be liable for incidental, special, or consequential dam-
return the Product to the Furman factory or to an authorized Furman repair location.
Manufacturer in writing of the claimed defects. If the defects are of such type and
sold hereunder will be free from defects in material and workmanship for a period
4-9925
nature as to be covered by this warranty, Manufacturer shall authorize Purchaser to
is mono, connect it to the Left Input. The HA-6A will then
stereo power amplifier substituting for it) would most likely be installed
Limited Warranty states the entire obligation of Manufacturer with respect to the
mic cable connects the first HR-2 to the second HR-2; a third mic cable
cians doing the overdub hear the already recorded tracks in their
Furman Sound, Inc.
Because of the presence of open microphones, headphones
or otherwise. Under no circumstances, whether based on this Limited Warranty or
authorization by Manufacturer.
cians' heads so that a minimal amount of sound leaks out.
cables can be used. The HA-6A connects to the first HR-2 box; another
the overdubbing process, where new musical tracks are recorded
nient. Or, the clip itself may be popped off the box for tabletop use.
Three Year Limited Warranty
ing added. It is generally derived from a "Cue" or "Headphone"
The cue mix heard in the headphones is a combination of
sole discretion if the product is modified in any way without written authorization
volume control, it is more practical to use several HR-2 Remote Stations
the previously recorded tracks along with the new sounds be-
automatically be in mono mode, so that the mix can be heard with both
man HA-6A or SP-20A is used to drive a chain of HR-2 Remote
products or components. This warranty shall be cancelable by Manufacturer at its
  [Pag.1]  

Esta version es la html del arhivo pdf HR-2_manual, genearada por domotica.name desde www.furmansound.com

Archivos relacionados:AC-215_datas ACD-100_data ACD-100_manu AR-1215_AR-2 AR-1215_manu AR-1230_data AR-15_datash AR-15_manual AR-20_datash AR-PRO_datas AR-PRO_manua ASD-120_data ASD-120_manu Furman_Merit Furman_Merit HDS-16_HRM-1 HDS-6_HR-6_d HDS-6_HR-6_m IT-1210_IT-1 IT-1230_manu IT-20_II_dat MERIT_SERIES MERIT_SERIES PL-8_PL-PLUS PL-8_PL-PLUS POWER_FACTOR POWER_FACTOR POWER_LINK_d POWER_STATIO PS-8R_II_dat PS-8R_II_man PS-8_PS-8R_P PS-8_PS-8R_d PS-PRO_II_ma PST-6_manual PST-8_D_manu RACKRIDER_PW RL-I_RL-LED_ RS-1_RS-2_ma SERIES_II_15 SERIES_II_15 SERIES_II_20 SERIES_II_20 SP-20A_datas SPB-8C_datas SPB-8C_manua SPB-8_datash SPB-8_manual audio acousticmagic acousticsfirst amina aperionaudio audiocontrol audioquest audioshare.net auralex bowers-wilkins bryston.ca caryaudio casatools cascadeaudio chillsound conextionsystems definitivetech eliteavdist furmansound lindelectronics martinlogan monitoraudiousa mseaudio nilesaudio noble-fidelity phasetech psaudio puristaudiodesign qsonix russound sheersoundcable sherbourn sonance ticcorp triadspeakers truaudio vdn-otl