FLPoolOMWMWQSver1_3aSMALL 9 | Biblioteca motores endlesspools

10.Attach the top bumper piece (length of PVC pipe) to the Swim Unit Housing through

14.Place the Swim Unit on the ground and roll it close to the Fastlane Pool location for

not over-tighten.

11.Attach the lower extension bumper (length of PVC flex pipe) to the rear of the Swim

tighten.

FLPoolOMWMWQSver1.3.a

are located between each wheel and the intake grill. Secure the wheels to the axle

12.Attach the wheels to the Swim Unit base. Slide the axle through the two holes that

6/16/08

been widened to allow the axle to pass through freely. There are a total of four large

Unit Base using the remaining two stainless steel screws from Step 9. NOTE: Do

with one smaller washer between the screw and the wheel on both sides.

Page 9 of 32

are marked in yellow on the intake grill in the Swim Unit base. These holes have

assembled Fastlane Swim Unit into the pool at the skimmer end. Lower and position

15.Once the pool is nearly full and the liner is taught and wrinkle-free, carefully lift the

installation. Be careful not to tip over the Swim Unit, as it is front-heavy.

as shown in Step 18. The Swim Unit should be centered along the end of the pool.

the Swim Unit so that the acrylic hanger "clips" on to the top straight tube (Part B)

two of the eight stainless steel screws provided in Step 9. NOTE: Do not over-

13.Re-install the throat that was removed previously in Step 4.

and two small washers used in the wheel assembly. Be sure that two large washers

the unused screw holes (top holes from Step 9) in the acrylic hanging bracket using