FLPoolOMWMWQSver1_3aSMALL 20 | Biblioteca motores endlesspools

Page 20 of 32

filter-heater connector to the filter and the white union half to the electric heater.

heater. There is a union that is connected to the pre-plumbed filter-heater connector

The plumbing connections of the electric heater should be on the same side as the

10.NOTE: If the optional gas heater or no heater has been purchased, please

onto the top connection of the electric heater. Connect the black union half of the

through the PVC Base. Use the provided nuts to secure the heater to the PVC Base.

proceed to Step 11. Otherwise, attach the electric heater to the PVC Support Base

6/16/08

FLPoolOMWMWQSver1.3.a

(Refer to Figure 4). Separate that union, and thread one half of it onto the bottom

connection of the electric heater. Locate the other pre-plumbed heater outlet

filter OUTLET. Use the provided Teflon tape on the threaded fittings of the electric

by placing the heater (with holes in its bottom flange) over the screws sticking

assembly (Refer to Figure 5), separate that union as well, and thread one half of it

Figure 4: Pre-plumbed Filter-Heater Connector (with Electric Heater ONLY)