FLPoolOMWMWQSver1_3a091108 9 | Biblioteca motores endlesspools

the unused screw holes (top holes from Step 9) in the acrylic hanging bracket using

10.Attach the top bumper piece (length of PVC pipe) to the Swim Unit Housing through

Unit Base using two 3/4" stainless steel screws. NOTE: Do not over-tighten.

back to the Power Unit, or they can be fed through the pool wall as described in

13.Re-install the throat that was removed previously in Step 4.

with one smaller washer between the screw and the wheel on both sides.

11.Attach the lower extension bumper (length of PVC flex pipe) to the rear of the Swim

and two small washers used in the wheel assembly. Be sure that two large washers

9/11/08

Page 9 of 32

15.Once the pool is nearly full and the liner is taught and wrinkle-free, carefully lift the

12.Attach the wheels to the Swim Unit base. Slide the axle through the two holes that

installation. Be careful not to tip over the Swim Unit, as it is front-heavy.

two of the ten 1" stainless steel screws. NOTE: Do not over-tighten.

assembled Fastlane Swim Unit into the pool at the skimmer end. Lower and position

as shown in Step 18. The Swim Unit should be centered along the end of the pool.

are marked in yellow on the intake grill in the Swim Unit base. These holes have

14.Place the Swim Unit on the ground and roll it close to the Fastlane Pool location for

the Swim Unit so that the acrylic hanger "clips" on to the top straight tube (Part B)

16.The hydraulic hoses can be simply left hanging over the top of the pool wall to run

are located between each wheel and the intake grill. Secure the wheels to the axle

been widened to allow the axle to pass through freely. There are a total of four large

FLPoolOMWMWQSver1.3.a