FLPoolOMDMver 9 | Biblioteca motores endlesspools

PVC Glue

(9) 90-degree elbow female slip x female slip

is connected to the LOAD side of the contactor and is to be hard wired into a junction box

WATER QUALITY SYSTEM, SKIMMER & THRU-WALL FITTINGS

A. Plumbing Kit

(1) Eyeball fitting male thread

(1) Tee, reducing, threaded

Teflon Putty

B. Box of Plumbing Parts

electricity for the ignition switch. The pump is intended to run continuously on low speed,

Fastlane Pool Package with optional 55,000 BTU Gas or Propane Heaters

to be hard wired into either the Gas or Propane heater in order to provide enough

that is mounted on the black equipment mounting board. Connecting to this junction box

Page 9 of 23

but can be switched to high speed manually for cleaning. The pump and the heater will be

(2) Union female thread x female slip

Tape measure

(1) 50' Roll of Flex PVC Pipe

Hack saw

The Hydraulic Power Unit (HPU) is shipped with two whips coming from the EP1 Controller

the LINE side of the contactor and is intended to supply power to the unit. The other whip

5/22/08

(1) Hose valve

(2) Thru-wall fitting female thread inside x female slip outside

FLPoolOMDMver1.2

(2) Adapter male thread x male slip

(4) Union female slip x female slip

switch on the rear of the pump by the electrician. The other, also done by an electrician, is

(2) Plug threaded

Teflon Tape

(4) Short Lengths of Rigid PVC Pipe

(13) Nipple

(3) Ball valve female slip x female slip

PVC Primer

C. Additional Tools Required

will be two whips. One is to be hard wired into the 220-volt, two-speed pump with the

able to run only when the Fastlane is not in use.

mounted on the HPU. One whip is to be wired by an electrician from the power source into

Quick Disconnect (included in pump box)

(2) 90-degree street elbow male thread x female slip