Assemblyinstr 9 | Biblioteca motores endlesspools

If you have purchased the optional 8" Aluminum Coping, which

of the pit before filling. Be sure not to brace back to a load-bear-

drilling fasteners provided. See Figure 8.2. Then lay out the

please call Customer Service.

are included in the kit along with a nut driver attachment for

has a liner hanger built into it, please refer to Section 14 and

Pools Customer Service with any questions.

nels is slightly higher than the surrounding top flange, EPI pro-

deflection is undesirable. For in-ground or partially in-ground

cut and pre-mitered to fit your pool. Only one long piece on

Fig 8.2: Installing the triangular inside corner supports.

Endless Pools simply brace or shim laterally back to the walls

Fig 8.3: 1/8" washer shims for leveling liner hanger.

place under the liner hanger and shim the pieces up to the level

nel and will protrude into the pool the thickness of the channel

8. Installation of the Liner Hanger

everywhere else. This is shown particularly well on the

the hydrostatic load but the pool walls will deflect slightly with-

prior to proceeding with your assembly.

ing wall unable to resist this lateral load. Please call Endless

Technical Bulletin #4B prior to proceeding with your assembly.

Fig 8.1:Triangular liner hanger box.

laterally before filling with water to reduce outward deflection

Fig 8.4: Short mitered liner hanger attached to the triangular inside corner supports.

each side needs to be trimmed to length. Self-drilling fasteners

Install the 4 triangular inside corner supports, using the self-

sion using a bead that is heat welded into the top edge of the

If you have purchased the optional Bullnose Coping,

Installation Video. Because the height of the 2 reinforcing chan-

long, triangular-shaped box. See Figure 8.1. The pieces are pre-

out bracing. When a rigid coping such as tile is planned this

nels supplied by Endless Pools Inc. are sufficient to withstand

liner. The liner hanger system is packaged in the pool crate in a

Fig 8.5: Caulking the liner hanger on the top.

your drill.

er pieces should be flush with the inside of the reinforcing chan-

vides 1/8" thick washers in the Pool Panel Hardware Kit to

any questions regarding these channels or their placement,

When possible, the walls of an Endless Pool

The aluminum liner hanger installs around the perimeter of the

which has a liner hanger built into it, please refer to Section 12

pool panel enclosure. The liner literally hangs from this extru-

entire system around the inside perimeter of the pool. The hang-

when the pool is filled with water. The steel reinforcing chan-

Ž should be braced