Assemblyinstr 20 | Biblioteca motores endlesspools

tings to the top of the valve assembly as shown in the drawing

the suction hazard and protect the pump in the event that the sys-

accompanying the valve assembly. See Figures 33.10 and 33.11.

The final opening on the front panel is the rectangular opening for

Service.

done with the previous thru-wall fittings. See Figure 33.9. Hand

tem is kept on with the water low. The final protection against

tighten the large hex nut and connect the hydraulic elbow fit-

a wrench to any of these fittings without first calling Customer

Fig 33.10: Hand tighten the hex nut to secure the hydraulic hoses.

Fig 33.12: Cutting the liner using the pool wall as a template.

Fig 33.9: Run the hydraulic hoses through the pool wall.

Fig 33.13: Installing the stainless steel shroud over the hydraulic and suction fittings.

Fig 33.8: A cork gasket is installed between the outside pool wall and the hex nut

the skimmer. See Figure 33.12. The skimmer will be plumbed to

turer's literature in the box. Use the silicone provided.

You may continue to fill the pool to a point three inches below

the bottom of the skimmer opening. In the unlikely event that

Figure 33.13. Plumb the skimmer as described in the manufac-

suction hazard is the stainless steel triangular shroud which

the suction fitting as shown in Tech Bulletin #3 in order to reduce

any of these fittings drips call Customer Service. Do not apply

installs over these inline fittings at the end of the installation. See

Fig 33.11: Attaching the hydraulic hoses to the valve assembly.