Assemblyinstr 19 | Biblioteca motores endlesspools

replace the round safety strainer fitting with a threaded plug

cork gasket. One rubber washer is placed between the liner and

eyeball fitting with a threaded plug with O-ring on the inside of

with O-ring. This will allow you to continue filling the pool

Before starting up be sure to remove these plugs and replace

is loosely installed for shipment. For the moment you may

Fig 33.3: Facing the propulsion assembly, the return fitting is on the left side.

hydraulic hoses. The thru-wall assembly is pretightened on each

Each of the thru-wall fittings has two rubber washers and one

Ultimately, the return fitting will have an eyeball fitting

Fig 33.2: Facing the propulsion assembly, the suction port is on the right side.

remove the hex nut, cork gasket and one rubber washer from

Fig 33.7: Install the second rubber washer between the fitting and the liner.

the pool. The suction fitting needs to have both a small adapter

the steel wall of the pool. See Figure 33.4. One rubber washer

Above the suction thru-wall are two thru-walls for two

the large hex nut that holds the fitting to the wall. See Figure

and round strainer screwed into it to eliminate the hazards of

Fig 33.6: Install one rubber washer between the liner and the pool wall.

each fitting and install them through the wall of the pool, as

suction at this fitting. See Figure 33.8. The safety strainer fitting

hose with the appropriate amount of teflon sealant. Simply

is placed between the fitting and the liner inside the pool. See

Figure 33.5. The cork gasket is placed outside the pool under

before completing the plumbing of the Water Quality System.

33.6. This nut should be tightened hand tight.

installed. See Figure 33.7. For the moment you may replace the

Fig 33.4: Installing the eyeball fitting into the return fitting.

them with the appropriate threaded pieces.

Fig 33.5: Installing the suction fitting with the strainer attached.