6-1. Extend X-armTM straight out from the wall by pressing the X-ARM button and then the SEL-
6-2. Run A/V cables on the left side using the large plastic hook. Wait to zip tie the AV cables.
Hook
through the small plastic hook and out the cable access hole. Then plug the IR Receiver
but not so long that they get caught in X-armTM parts. Test this by pressing the X-ARM
through the hole in the base plate as shown.
6-5. The AV, power cord, and IR Receiver cables must be long enough to connect equipment,
AV Cable
IR Receiver Eye
IN/OUT button on the remote once while aiming at the IR Receiver.
6-6. Using the provided zip ties, fasten all cables to the cable bar located near the cable access
Access Hole
No Cable
from the center beam. Cut off the excess zip tie ends.
TV Cord Keeper
TV power cord keeper and replace the cover.
Bottom Cross Bar
Center
Cable
Bellows
Beam
Cover of
back into the side of X-armTM.
(Accessible through hole in X-arm backplate)
Power
No Cable
to TV
button on the remote and then the SEL- IN/OUT button to extend X-armTM. Tilt and swivel it
2"
side to side using the arrow buttons.
www.closystems.com
between the bellows and the cross bar. The TV power and A/V cables should be at least 2"
b. Remove the side of the TV cord keeper, coil up the excess power cord, place it in the
2"
IR Reciever Cord
these directions.
Use if power outlet is inside bellows.
6-7. Using the provided zip ties, fasten the cables to the lower cross bar so that they pass
hole at the back of X-armTM.
AV Cables from
c. Run the X-armTM power cord up through the cable access hole and plug it in, gathering
to TV
6-3. a. Run the TV power cable between the bottom cross bar and bellows and plug it in
Component
Power outlet in belows.
6-4. Unplug the IR Receiver and run the plug-in end up between the bellows and the cross bar,
If the power outlet for your TV and X-armTM is located outside the bellows of X-armTM, follow
Cord Keeper
Cable Bar
AV Cables
to X-arm
9
the excess with a cable tie. Fasten it to the cable bar with another zip tie.
<< < [Pag.9] > >>
Esta version es la html del arhivo pdf x_arm_manual, genearada por domotica.name desde www.closystems.com
Archivos relacionados:84 ElectronicKi X-Arm-Instal X-Arm-Specif clo_listino newsletter20 motores activateddecor aquaair-wetdry auton avrak closystems endlesspools hpproducts.net innovativepools mediadecor peerlessmounts plasma-tv-lift silentgliss-usa somfysystems watercop
