Cinema1 9 | Biblioteca audio caryaudio

your installation set-up requires. The choice of a high quality shielded interconnect cable is important.

OPERATION ________________________________________________________

Do not touch the speaker output binding posts during normal operation. You may be shocked.

trigger operation.

music or start the movie. Flip the main power switch to OFF for normal shut down and for remote turn on

Your new power amplifier is ready for operation after installing the AC power cord, the speaker and

blow. Do not parallel or "bridge" the speaker output binding posts as this will damage the

not easily solved, we suggest that you contact our Customer Service Department by phone at (919) 355-

Once again, your audio dealer will have the proper cables in stock for this purpose.

Push the main power switch on the front panel to the "ON" position for normal use. Set the Cinema 1

Factory Service

to the factory without a Return Authorization Number (RA) from the Customer Service Department.

minimum. If problems arise, refer to the troubleshooting guide at the end of this manual. If the problem is

amplifier.

particular usage and installation.

`feather duster' type cleaner will also work well for cleaning the component.

by the trigger in the surround sound processor. LED's 1 or 1-2 will light up. At this point you can play

through `break in.' After the first couple of hours you will notice increased image depth and tighter bass.

Break In Period

On-Off Power Switch

preamplifier. They may remove the labels from the chassis. The frequency and need of cleaning will be

WARNING

Careful consideration has been given to the design of this product to keep maintenance problems to a

0010, 15 pm Eastern Standard Time, to describe your problem in detail. DO NOT return the component

Do not short-circuit the speaker output binding posts. Damage may occur or the fuse may

governed by operating environmental conditions. Avoid letting the component become dusty or wet. A

performance. The power amplifier will sound good right out of the box and continue to improve as it goes

interconnect cables. Make sure that the RCA/XLR switch is in the proper input selector position for your

The transistors and capacitors take approximately 100 hours of music playing to fully settle in for peak

SERVICE AND CARE ________________________________________________

amplifier for remote turn on/off operation by leaving it in the OFF position and it will be turned on and off

cleaning cloth to moisten it, not on the component. Do not use solvents or harsh chemicals to clean the

The chassis may be cleaned with a soft towel and Windex® or a similar window cleaner. Spray it on the