CAI1 9 | Biblioteca audio caryaudio

connections without the use of tools such as nut drivers. A simple finger-tightening

* Provides audio output. Two pairs of custom-made, high-current binding posts

labeled + (positive) and - (negative) are included.

Rear Panel

Pin 3: Signal - (inverting)

NEVER connect power amplifier outputs to any component other than a loudspeaker.

Pin 2: Signal + (non-inverting)

Pin 1: Signal ground

BALANCED INPUTS:

such as tuners, CD player, and SACD player.

* Accepts right-channel and left-channel (RCA) inputs from line-level source equipment

Connector ground lug: chassis ground

* These binging posts are designed to facilitate high pressure, high contact area

actually yields higher contact pressure than traditional hex binding posts. There is

connections can be achieved with finger-tightening.

NEVER short-circuit power amplifier outputs.

to the equivalent input pin.

Refer to the operating manuals of your balanced-output line-level sources

NEVER connect power amplifier outputs to another power amplifier's outputs.

with balanced outputs.

the CAI 1. If not, wire the cable so that the appropriate output pin connects

"wing"-turning, slide it into place when the binding post opening provides a snug fit.

no need to exert unusual effort when tightening.

DO NOT OVERTIGHTEN the CAI 1 binding posts. Tight, high-contact pressure

to verify that the pin assignments of their output connectors correspond to

Then, use quarter-turns to tighten the connection as needed.

DO NOT FORCE the CAI 1 binding post "wings" up and over a bent or oversized

* The pin assignments of these XLR-type female input are:

LOUDSPEAKER BINDING POSTS (OUTPUTS):

SINGLE-ENDED INPUTS:

connector. Doing so may result in binding post damage. If the connector obstructs the

* CAUTION!

* Accepts right-channel and left-channel balanced signals from source equipment