CAD500-200 9 | Biblioteca audio caryaudio

performance. The power amplifier will sound good right out of the box and continue to improve as it goes

Signal input connections are made on the rear of your CAD 500 MB or Cary Cinema power amplifier,

Push the main power switch on the front panel to the ON position for normal use. (Set CAD 500 MB, CAD

On-Off Power Switch

convenient length your installation set-up requires. The choice of a high quality shielded interconnect

purpose. Consult your Authorized Cary Audio Design Dealer for advice about wire.

distances up to 10 feet, #12 for 25 feet. Most audio dealers will have proper speaker cable in stock for this

through `break in.' After the first couple of hours you will notice increased image depth and tighter bass.

speaker and interconnect cables. Make sure that the RCA/XLR switch is in the proper input selector

Do not touch the speaker output binding posts during normal operation. You may be shocked.

WARNING

position for your particular usage and installation.

normal shut down.

Your new CAD 500 MB or CAD 200 amplifier is ready for operation after installing the AC power cord, the

selecting either single ended RCA connections or XLR balanced inputs. The interconnect cables can be any

cable is important. Once again, your audio dealer will have the proper cables in stock for this purpose.

blow. Do not parallel or "bridge" the speaker output binding posts as this will damage the

Break In Period

processor.) At this point you can play music or start the movie. Flip the main power switch to OFF for

Interconnects

The transistors and capacitors take approximately 100 hours of music playing to fully settle in for peak

200 for remote turn on/off operation and it will be turned on and off by the trigger in the surround sound

amplifier.

Do not short-circuit the speaker output binding posts. Damage may occur or the fuse may

OPERATION ________________________________________________________