quickneasyinstal0907 2 | Biblioteca actuadores automatedceilingregisters

3. After the ceilings are textured and painted, simply push the register assembly

that may be painted or stained if desired.

Quickneasyinstall0907.pdf

firmly anchored inside the extruded bead in the collar.

(manual or automated) up and into the access hole (prepared during rough-in) until the

2. Note: Trim Rings may be installed before or after the ceilings or walls are textured and painted.

Figure 10 - Releasing Springs

Instructions for more details on automated models.

Figure 8 - Installed Register

Don't forget to plug in the modular cable if installing the 100A-R or connect the three

Collar/Plate using a thick coating of mastic to provide an airtight seal between the collar and the sheetrock or

in Trim Rings (Fig. 7). Three models of register assemblies are available: Model 100M-R, Manual, 100A-R,

QUICK & EASY

Figure 9 - Release Tool

wallboard. The plate must be flush with the backside of the sheetrock or wallboard

FINISH KIT INSTALLATION INSTRUCTIONS

from getting above the trim ring and then on the locking spring tips when the register assembly is

sheetrock or wallboard interface to prevent movement and air leakage. The register assembly has a matte finish

4. A small bead of caulk MUST BE APPLIED around the outside perimeter of the valve seat at the

Figure 7 - Trim Ring

Figure 6 - Manual Air Valve Assembly

Figure 5 - 16 Finish Kits

Complete Quick & EasyTM Ceiling Register Installation Instructions are provided as two separate

two flat steel springs snap into the special extruded bead in the register collar (Fig. 8).

wires to the 100A3W-R. IMPORTANT - Open the register, gently pull down on

Finish kits (Fig. 5) consist of sixteen (16) QUICK & EASY

installed.

TM register assemblies (Fig. 6) and sixteen (16) press-

1. Make sure there is no debris or caulk between the flat plate (of the Collar/Plate) and the sheetrock or

wallboard. IMPORTANT - Paint mastic in 3/4 inch wide or less strip around collar to keep wet mastic

TM CEILING REGISTER

Use upper inside edge of collar to pull plate down flush with the wallboard and install trim ring inside the

the register assembly to make certain that the sharp ends of both steel springs are

automated, and 100A3W-R, automated (3-wire interface.) See Automated Ceiling Register Installation

Installation Steps

documents: The Finish Kit and The Rough-In Kit (on opposite side of this page.)

(OVER)

springs as shown in Figure 10.

5. To remove register, use special tool (model 100T) Figure 9 to depress