Specifications_SonoFiber 2 | Biblioteca audio auralex

b) Other: Provide materials necessary for alternate permanent mounting to walls and/or

methods acceptable to manufacturer.

b) Replace damaged components as directed by the Architect.

c) Remove debris caused by work of this section on a daily basis. At completion of acoustical

printed instructions, using approved mounting methods.

a) After installation of acoustical panels, clean all dirty surfaces, using cleaning materials and

Products

b) Substitutions are not acceptable.

4. Edges: Square.

6. Color: Charcoal Gray.

2.1. Manufacturers

3. Thickness: 1 inch (25.4 mm).

ceilings as described in acoustical treatment design documentation.

2. Length: 24 inches (609.6 mm).

surfaces.

5. Corners: Square.

3.3. Adjust and Clean

2.2. SonoFiberTM sound absorptive panels

Court, Indianapolis, Indiana 46250-2039. Tel. (317) 842-2600. Fax: (317) 842-2760.

2.3. Mounting Components

a) 1" SonoFiberTM. Natural fiber panel (no facing).

End of Section

a) Examine surfaces to receive work of this section. Do not begin installation until

Execution

3.2. Installation

Owner/Architect.

1. Wideness: 24 inches (609.6 mm).

03/04/2007

b) Install each panel as indicated on shop drawings and in accordance with manufacturer's

panel installation, remove all crates, cartons, packages and debris from the project site.

unsatisfactory conditions have been corrected. Mounting surfaces shall be smooth, clean

a) Install panels on walls and ceilings in locations and in patterns indicated on the drawings.

3.1. Examination

a) Auralex FoamtakTM spray adhesive or approved equivalent to be used to adhere panels to

a) Provide sound absorptive panels as manufactured by Auralex Acoustics, Inc., 6853 Hillsdale

2/2

and dry. Drywall surfaces, if not painted, shall be sanded, primed and painted per the