epicenter_OM 9 | Biblioteca audio audiocontrol

ing the circuit board and rotary control from the bracket. Drill a 9/32" hole in

Dash Bracket Installation

dash mount remote

For that custom, finished look, the dash

turn it 180 degrees and plug it back in.

Epicenter dash control from

Dash Control Installation

Figure 5, disassemble The

make this happen. Referencing

wish to change the color to amber, remove the plug connected to the LED and

control can be flush mounted directly

holder followed by remov-

on the dash board (or anywhere else).

by pushing the LED from its

position, mark the two mounting holes, drill pilot holes, and secure with

Custom Installation

two screws.

The dash control may be mounted under the dash using its own bracket or

Figure 5: Picture of

in a spot where the LED is plainly visible.

The LED on your dash control is rainforest green and should brighten or

page 9

Placement And Mounting

through a custom hole in the dash. It should be within reach of the driver and

dim when you turn the knob either clockwise or counter clockwise. Should you

The dash control mounts with two screws which attach to the underside of

Dual-Color Dash Control LED

the dashboard for the control along with a 1/8" hole for the lock tab and a 13/

64" hole for the LED holder. Reassemble the dash control components on the

the mounting bracket. Start

We have provided an extra label to help

dashboard and apply the new label over the openings.

the dashboard. Slide under the dash and place the dash control in its mounting