swivel-instructions Biblioteca motores activateddecor

Using Hand-Held Programmable Switch

Motorized Flat Panel Lifts

8. If the "Red Light" of the center verification sensor is off, the lift will not lower by itself when centered. Using a Phillips

Pressing "S", then "3" sets the "counterclockwise" swivel stop point.

3. Use the "arrows" on the switch to swivel to the "Clockwise" position.

768 Templemead Drive, Hamilton, ON, L8W 2V7

Note: It's best to first set S1, then S2, and finally, S3 in that order.

6. Center Position is set using "S" and "2". You should not have to alter this setting which has been set at the factory.

Activated Décor, INC.

5. Repeat for "Counterclockwise" position, pressing "S" then "3" to save setting

Setting Swivel Stop Points

Phone: 905-388-0003 Fax: 905-388-0795

Pressing "S", then "2" sets the "center" position.

Email: info@activateddecor.com

4. Press "S", release, then, press "1" to save setting.

optic sensor located on side of swivel motor).

Web Address: www.activateddecor.com

*Pressing "S", then "1" sets the "clockwise" swivel stop point.

1. Unplug existing "switch lead" from the SWIVEL control box.

7. Unplug programmable switch from control box and replace with original switch lead.

screwdriver, adjust sensor to align with hole in swivel platform. The red light will turn on when in the correct location. (fiber

2. Plug "programmable switch" into this control box.